| |
| 1 | 2 | 3 |
1 - Free standing walls
2 - Walls connecting floor and ceiling
3 - Finishing
|
1 - FREE STANDING WALLS
Measure the profiles.
Leave 1 cm between the block and the profile. |
| |
 |
|
 |
| |
 |
|
 |
|
Cut the profiles to size.
Cut the tube to a diameter of 3 mm. |
| |
 |
|
Check that the angle between the wall and the floor is 90°.
Glue the horizontal profile to the floor.
Glue the vertical profile to the wall. Check that the profile is completely vertical . |
| |
 |
|
 |
|
Use only the amount of glue necessary for each glass block. |
| |
 |
|
 |
|
Glue one of the short profiles to one side. |
| |
 |
|
 |
|
Repeat the process until the first row has been completed. |
| |
 |
|
Place a horizontal profile between each row of glass blocks.
Glue the horizontal profiles to the lower row. |
| |
 |
|
For lengths greater than one metre alternate the position of the profiles in each row. |
|
| |
 |
|
Repeat the process until the required height has been reached.
Periodically check that the wall is vertical. |
|
top
< back to General information |
| |
| For further information, please refer to Quickteck System brochure. |
