|
| 1 | 2 |
1 - Installation
2 - Finishing
|
| 1 - INSTALLATION |
| |
| Curved walls: |
| |
 |
|
Use 18cm profiles horizontally and angular section profiles vertically. |
| |
 |
|
Positioning the 18cm profiles between floor and glass block, then positioning the angular ones with different high alternately between one block and the following. |
| |
 |
|
Cut the angular profiles with the same measure of the high of the wall. Insert the 18cm profiles between one block and the following to calculate the length of the profile.
N.B. For high>48cm, positioning the shorter angular profile, then the longer one, to join the desired high, after they have been measured and cut. In the following column proceed inverting the sequence and cut the shorter profile according to the desired high of the wall (in both cases leave 1cm respect the high of the last block). |
|
 |
|
Glue a 18cm profile to the floor, then glue a glass block on it (for glass block feathered wall, start with a long angular profile, then fix the 18cm profile at the floor). |
|
 |
|
Glue an angular profile to the lateral side of the glass block. Repeat the steps n.3-4 to complete the row. |
|
 |
|
 |
|
Proceed with the installation gluing the glass block sto the horizontal profile and to the vertical ones on both sides of the block. |
|
|
top
< back to General information |
| |
Energy Saving
